SURFACE PREPARATION: the product is applied on mineral surfaces such as cement, concrete, marble and wood. In the case of application on absorbent mineral surfaces, a preliminary coat of the product diluted to 20% is necessary as a primer. Concrete surfaces: make sure that the surface is clean, dry, free from grease, grease and contaminating material, any oil stains must be previously removed by washing with a specific detergent ZERO OILIf necessary, sand and vacuum the surface.

PRODUCT PREPARATION: mix with a drill equipped with a stirrer, at low speed, until a homogeneous solution is obtained without foam. Mix the two components in a ratio of 3 parts of component A with 1 part of component B (mixing ratio 3:1) then apply uniformly to the surface within 15 minutes using a suitable wax spreader or short-haired roller (MOHAR) or with an airless spray pump. Plan to apply two coats of product. Mix only the quantities that can be used within the maximum workability time.

APPLICATION: apply POLYLUX FINISH at temperatures above 10°C. Do not apply under direct sunlight, wind, fog or rain. The product is sensitive to frost.

CLEANING OF TOOLS: The equipment used must be cleaned immediately after use with plenty of running water. Once the product has hardened, removal can only be carried out mechanically.